Honda Civic 2002-2003 Service Manual page 1117

SRS
SRS Indicator Circuit Troubleshooting (cont'd)
3B. Remove the gauge assembly (see page 22-64), then
disconnect gauge assembly connector A from the
gauge assembly.
A
39. Check resistance between the No.5 terminal of
SRS unit connector C (BP) and body ground. There
should be an open circuit, or at least 1 M
Q.
SRS UNIT CONNECTOR C 18PI
Wire side offemale terminals
Is the resistance as specified?
YES-Faulty SRS indicator circuit in the gauge
assembly; replace the gauge assembly .•
NO-Short to ground in the floor wire harness or in
dashboard wire harness A; replace the faulty
harness .•
23-110
40. Remove the gauge assembly (see page 22-64), then
disconnect gauge assembly connector A from the
gauge assembly.
A
41. Check resistance between the No. 14 terminal of
gauge assembly connector A (22P) and the No.5
terminal of SRS unit connector C (SP). There should
be 1
Q
or less.
SRS UNIT CONNECTOR C 18PI
PNK
'---------{Q)---,
Wire side offemale terminals
GAUGE ASSEMBLY CONNECTOR A 122P}
Is the resistance as specified?
YES-Faulty SRS indicator circuit in the gauge
assembly or poor contact at gauge assembly
connector A (22P); check the connection. If the
connection is OK, replace the gauge assembly .•
NO-Open in the floor wire harness or in
dashboard wire harness A; replace the faulty
harness .•
4'