Honda Civic 2002-2003 Service Manual page 1046

•
,
DTe 1-4: Short to Power in Driver's Airbag
Inflator
Special Tools Required
• SRS inflator simulator 07SAZ-TB4011A
• SRS simulator lead F 07XAZ-SZ30100
1. Erase the DTC memory (see page 23-26).
2. Turn the ignition switch ON (III, and check that the
SRS indicator comes on for about 6 seconds and
then goes off.
Does the SRS indicator stay on?
YES-Go to step 3.
NO-Intermittent failure, system is OK at this time.
Go to Troubleshooting Intermittent Failures (see
page 23-261.
3. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
4. Disconnect the driver's airbag 4P connector (A)
from the cable ree1.
A
---4-~.
....•
/
. ? {
07SAZ-TB4011A
/
~-"
07XAZ-SZ30100
=W
5. Connect the SRS inflator simulator (2
Q
connectors) and the simulator lead F to the cable
reeL
6. Reconnect the battery negative cable.
7. Erase the DTC memory.
8. Read the DTC.
Is OTe 1-4 indicated?
YES-Go to step 9 .
NO-Short to power in the driver's airbag; replace
the driver's airbag (see page 23-1131 .•
9. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
10. Disconnect the front passenger's airbag 4P
connector from dashboard wire harness B (see step
3 on page 23-211.
11. Disconnect both seat belt tensioner 2P connectors
from the floor wire harness (see step 5 on page 23-
221.
12. Disconnect SRS unit connector A (18PI from the
SRS unit (see step 7 on page 23-221.
13. Disconnect the special tool from the cable reel.
14. Reconnect the battery negative cable.
(conl'dl
23-39