Table of Contents
Advertisement
l
,
, J
Wiring Precautions
Some of the SRS wiring can be identified by a special
yellow outer covering, and the SRS connectors can be
identified by their yellow color.
Observe the instructions described in this section.
• Never attempt to modify, splice, or repair SRS wiring.
If there is an open or damage in SRS wiring, replace
the harness.
Be sure to install the harness wires so they do not get
pinched or interfere with other parts.
Make sure all SRS ground locations are clean, and
grounds are securely fastened for optimum metal-to-
metal contact. Poor grounding can cause intermittent
problems that are difficult to diagnose.
Precautions for
Electrical Inspections
• When using electrical test equipment,
insert the
probe of the tester into the wire side of the connector.
Do not insert the probe of the tester into the terminal
side of the connector, and do not tamper with the
connector .
c
o
==c~
• . __ /
• Use a U-shaped probe. Do not insert the probe
forcibly.
c-.--------~t:=)~ ____ _
Use specified service connectors in troubleshooting.
Using improper tools could cause an error in
inspection due to poor metal-to-metal contact.
(cont'd)
23-17
Advertisement
Table of Contents
Troubleshooting
