Honda Civic 2002-2003 Service Manual page 1101

SRS
DTe Troubleshooting (cont'd)
OTC 14-3: No Signal from the Front
Passenger's Side Impact Sensor
Special Tools Required
• SRS inflator simulator 07SAZ-TB401 1A
• SRS simulator lead H 07YAZ-S3AA100
1. Erase the DTC memory Isee page 23-261.
2. Turn the ignition switch ON III), and check that the
SRS indicator comes on for about 6 seconds and
then goes off.
Does the SRS indicator stay on?
YES-Go to step 3.
NO-Intermittent failure, system is OK at this time.
Go to Troubleshooting Intermittent Failures Isee
page 23-26).
3. Turn the ignition switch OFF. Disconnectthe
battery negative cable, and wait for 3 minutes.
4. Check the connection between the floor wire
harness 2P connector and the front passenger's
side impact sensor.
(s
the connection OK?
YES-Go to step 5.
NO- Poor contact between the floor wire harness
2P
connector
and the front passenger's side impact
sensor; replace the front passenger's side impact
sensor and/or the floor harness, as needed.
23-94
5. Disconnect the driver's side airbag and front
passenger's side airbag 2P connectors (see step 4
on page 23-211. Also disconnect both seat belt
buckle tensioner 4P connectors Isee step 6 on page
23-22) .
6. Disconnect the floor wire harness 2P connector IA)
from the front passenger's side impact sensor.
7. Connect the SRS inflator simulator 12
Q
connector)
and the simulator lead H to the floor wire harness.
J