Srs Unit Replacement - Honda Civic 2002-2003 Service Manual

SRS
SRS Unit Replacement
Removal
1. Disconnect the battery
negative
cable, and wait at
least 3 minutes before beginning work.
2. Disconnect the driver's and front passenger's
airbag connectors (see page 23-21).
3. Disconnectthe side airbag connectors (see page
23-21).
4. Disconnect both seat belt tensioner connectors (see
page 23-22) and both seat belt buckle tensioner
connectors (see page 23-22).
5. Remove the dashboard center lower cover (see
step 2 on page 20-57).
6. Pull down the console carpet on the passenger's
side, then remove the Torx bolt (A) from the SRS
unit.
A
7. Pull down the console carpet on the driver's side,
then disconnectthe connectors. Remove the Torx
bolts (A), then pull out the SRS unit.
A
23-122
Installation
1. Install the new SRS unit (A) with Torx bolts (8), then
connect the connectors
(e)
to the SRS unit; push
them into position until they clicks.
NOTE: When tightening the Torx bolts to the
specified torque, be careful to turn them in so that
their heads rest squarely on the brackets.
B
9.S N·m
(1.0
kgf·m, 7.2Ibf·fll
c
2. Reinstall the dashboard center lower cover (see
step 2 on page 20-57).
3. Reconnect the driver's and front passenger's airbag
connectors (see page 23-21).
4. Reconnect the side airbag connectors (see page 23-
21).
5. Reconnect both seat belt tensioner connectors (see
page 23-22) and both seat belt buckle tensioner
connectors (see page 23-22).
6. Reconnect the battery
negative
cable.
7. Initialize the OPDS unit (see page 23-27).
8. After installing the SRS unit, confirm proper system
operation: Turn the ignition switch ON (II); the SRS
indicator should come on for about 6 seconds and
then go off.