Honda Civic 2002-2003 Service Manual page 439

•
Special Tools Required
• Driver, 40 mm I.D. 07746-0030100
• Anachment, 30 mm I.D. 077 46-0030300
NOTE: Refer to the Exploded View as needed during
this procedure.
1. Clean all the parts in solvent, dry them, and apply
lubricant to all contact surfaces except the 3rd/4th
and 5th synchro hubs.
2. Install the needle bearing and 3rd gear on the
mainshaft.
3. Install the synchro ring and the synchro spring.
4. Install the 3rd/4th synchro hub IAI by aligning the
synchro ring fingers 181 with 3rd/4th synchro hub
grooves ICI.
5. Install the 3rd/4th synchro hub IA) using the special
tool.
6. Install the 3rd/4th synchro sleeve IA) by aligning
the stops 18) with the 3rd/4th synchro sleeve and
hub. After installing, check the operation of the 3rd/
4th synchro hub set.
7. Install the synchro spring IA).
____ 8
c
D
8. Install the synchro ring 18) by aliging the synchro
cone fingers IC) with 3rd/4th synchro hub grooves
ID).
9. Install the 4th gear, needle bearing, distance collar,
needle bearing, and 5th gear .
Iconl'd)
13-29