Honda Civic 2002-2003 Service Manual page 612

•
•
S. With a feeler gauge (AI, measure the clearance
between the gauge body and the adjusting nut (81
as shown.
If the clearance between the gauge body and the
adjusting nut is 0.4 mm (0.02 in.l, the pushrod-to-
piston clearance is 0 mm. However, if the clearance
between the gauge body and the adjusting nut is
o
mm, the pushrod-to-piston clearance is 0.4 mm
(0.02 in.1 or more. Therefore it must be adjusted
and rechecked.
Clearance: 0-0.4 mm (0-0.02 in.1
6. If the clearance is incorrect, loosen the star locknut
(AI, and turn the adjuster (81 in or out to adjust .
• Adjust the clearance while the specified vacuum
is applied to the booster.
• Hold the clevis (CI while adjusting.
0-0.4mm 10-0.02in.1
~I"
.
~
'j
I
I"i'""'~
I
I
A
22N·m
' ' ' " ' r ' ' · ·
a
/
I
\\
D
07JAG·SD40tOO
7. Tighten the star locknut securely .
8. Remove the special tool (DI.
B
C
9. Check the pushrod length (AI as shown if the
booster is removed. If the length is incorrect,
loosen the pushrod locknut (81, and turn the clevis
(CI in or out to adjust.
A
116 mm
14.6 in.1
•
B
10x 1.0mm
1.5N·m
.'
11.5 kgf·m, lllbf·ftl
10. Install the master cylinder (see page 19- lSI .
19-17