Table of Contents
Advertisement
•
•
Passenger's Dashboard Lower
Cover Removal/Installation
NOTE: Take care not to scratch the dashboard and
related parts.
1. Remove the passenger's dashboard lower cover
(A).
-1
Gently pull down the rear edge to release the
clips
(8).
-2
Pull the cover away to release the pins
(e)
from
the holders
(D).
Fastener Locations
B~:
Clip,
3
!J.
.
'.
B
"
-
B
."1.
B
~A
2. Install the under cover in the reverse order of
removal, and push the clip portions into place
securely.
Glove Box Removal/Installation
SRS components are located in this area. Review the
SRS component locations (see page 23·13) and the
precautions and procedures (see page 23·14) in the SRS
section before performing repairs or service.
NOTE: Take care not to scratch the dashboard and
related parts.
1. Remove the passenger's dashboard lower cover.
2.
While holding the glove box
(A),
remove the glove
box stop
(8)
on each side.
Fastener Locations
~Bolt,2
~
- =-=-=-::::--=::_-
---
B
.... _ _ _ -- 5 x 0.8 mm
•
5N·m
(0.5 kgf·m,
4 Ibf·ftl
3. Remove the bolts, then remove the glove box.
4. Install the glove box in the reverse order of
removal.
20-63
Advertisement
Table of Contents
Troubleshooting
