Honda Civic 2002-2003 Service Manual page 697

•
•
6. To remove a front drain valve (A) from the body,
remove the kick panel, left or right (see page 20-50).
Tie a string to the end of the drain tube, then pull
the front drain tube (B) down out of the front pillar.
7. To remove a rear drain valve (A) from the cargo
compartment, remove the rear side trim panel (see
page 20-51 ).Detach the clips (B), then remove the
drain tube (C).
B
==
8. Install the frame and drain tube in the reverse order
of removal, and note these items:
Before installing the frame, clear the drain tubes
and drain valves using compressed air.
Check the frame seal.
• Clean the surface of the frame.
• When installing the frame, first attach the rear
hooks into the body holes.
• Make sure the connectors are plugged in
properly.
• When connecting the drain tube, slide it overthe
frame nozzle at least 10 mm (0.39 in.).
Install the tube clip (A) on the drain tube (B) as
shown.
/"
"
Upward
1
B
9. Check for water leaks. Let the water run freely from
a hose without a nozzle. Do not use a high-pressure
spray .
20-43