Install The Power, Fim, Disk Backplane Data, And Dvd Cables - Oracle X6-2 Service Manual

Install the Power, FIM, Disk Backplane Data, and DVD Cables

a. To eject the auxiliary power and signal cable from the motherboard, open the
latches on the connector [3].
To eject the auxiliary power and signal cable from the disk backplane, open
b.
the latches on the connector [4].
5. To remove the FIM cable, perform these steps:
a. Remove the FIM from the server.
See
b. Disconnect the FIM cable from the FIM [5].
c. To eject the FIM cable from the motherboard, open both side latches [6].
6. To remove the DVD cable, perform these steps:
a. If there is a PCIe card installed in PCIe slot 2, remove the PCIe riser and card
from PCIe slot 2.
See
b. Disconnect connect the DVD cable from the motherboard [7].
c. Disconnect the DVD cable connector from the rear of the DVD drive and the
DVD power connector from the disk backplane [8].
Related Information
"Install the Power, FIM, Disk Backplane Data, and DVD Cables " on page 184
■
Install the Power, FIM, Disk Backplane Data, and
DVD Cables
Caution -
installed only by authorized Oracle Services personnel.
Install the DVD cable.
1.
Connect the DVD cable to the rear of the DVD drive and the DVD power
a.
connector to the disk backplane (See
184 Oracle Server X6-2 Service Manual • June 2016
"Remove the Front Indicator Module" on page 159
"Remove a PCIe Riser From PCIe Slot 1 or 2" on page 99
The Power, front indicator module, disk backplane data, and DVD cables should be
Figure 33 [8]).