Servicing an Internal USB Flash Drive (CRU)
This section describes how to service a USB flash drive. The USB flash drive is a customer-
replaceable unit (CRU) that requires you to power off the server. For more information
about CRUs, see
Units" on page
These procedures require that you handle components that are sensitive to static
Caution -
discharge. This sensitivity can cause the component to fail. To avoid damage, ensure that you
follow antistatic practices as described in
Ensure that all power is removed from the server before removing or installing a
Caution -
flash drive or damage to the drive might occur. You must disconnect all power cables from the
system before performing these procedures.
This section covers the following procedures:
"Remove an Internal USB Flash Drive" on page 93
■
"Install an Internal USB Flash Drive" on page 94
■
Related Information
"USB Ports" on page 221
■
Remove an Internal USB Flash Drive
The server can be equipped with one internal USB flash drive.
Prepare the server for service.
1.
Power off the server, and disconnect the power cords from the power
a.
supplies.
See
"Powering Down the Server" on page
"Illustrated Parts Breakdown" on page 19
21.
and
"Customer-Replaceable
"Electrostatic Discharge Safety" on page
53.
Servicing an Internal USB Flash Drive (CRU)
50.
93