Oracle X6-2 Service Manual page 242

BIOS Advanced Menu Selections
Setup Options
Connection Retry Count
Connection Establishing
Timeout
Configure ISID
Enable DHCP
Initiator IP Address
Initiator Subnet Mask
Gateway
Target Name
Target IP address
Target Port
Boot LUN
Authentication Type
242 Oracle Server X6-2 Service Manual • June 2016
Options Defaults
0 to 16 0
NA 1,000
Derived from the MAC The default value is
address derived from the Mac
Address
Disabled/Enabled Disabled
NA 0.0.0.0
NA 0.0.0.0
NA 0.0.0.0
NA NA
0.0.0.0 None
3260
0
CHAP/None CHAP
Description
iSCSI target using the IPv4
stack. If this fails, then
the iSCSI driver attempt
to connect using the IPv6
stack.
The count range is 0 to
16. If set to 0, there are no
retries.
The timeout value
in milliseconds. The
minimum value is 100
milliseconds and the
maximum is 20 seconds.
The OUI-format ISID is
6 bytes. The default value
is derived from the MAC
address. Only the last 3
bytes are configurable.
Example: Update
0ABBCCDDEEFF to
0ABBCCF07901 by
inputting F07901
Enable or disable DHCP
Use to set initiator IP
address in dotted-decimal
notation.
Use to set initiator subnet
mask IP address in dotted-
decimal notation.
Use to set initiator gateway
IP address in dotted-
decimal notation.
The worldwide unique
name of the target. Only
IQN format is accepted.
Use to set target IP address
in dotted-decimal notation.
Use to change target port
number.
Use to set the hexadecimal
representation of the
boot logical unit number
(LUN).
Example: 4752-3A4F-
6b7e-2F99
Define the Challenge-
Handshake Authentication
Protocol (CHAP).
Available settings are