Servicing The Usb Drives (Cru); Removing The Usb Drive - Oracle Sun Blade X6275 Service Manual

3.2

Servicing the USB Drives (CRU)

The USB drives might contain the boot OS. Two USB drive ports are located on the
rear of the server module motherboard, under the SP board. The top USB port is for
compute node 0. The bottom USB port is for compute node 1.
Note – CRU: This customer replaceable unit can be replaced by anyone.
3.2.1

Removing the USB Drive

1. If necessary, back up any data that is contained on the USB drives.
2. Prepare the server module for service.
a. Power off both server module compute nodes.
b. Remove the server module from the Sun Blade chassis. Place it on a flat
c. Attach an antistatic wrist strap.
3. Locate the USB port on the back of the motherboard. See
4. Grasp the USB drive, and pull the USB drive out.
5. Repeat
See Section 2.4, "Powering Off the Server Module" on page
surface.
See Section 2.5, "Removing the Server Module From the Sun Blade Chassis" on
page 2-7.
See Section 2.6, "Performing Electrostatic Discharge and Antistatic Prevention
Measures" on page 2-9.
Step 4 for the second USB Drive.
Chapter 3 Servicing Server Module Components
2-4.
.
FIGURE 3-8
3-15