Power On The Server - Oracle X6-2 Service Manual

Power On the Server

3. If necessary, reinstall the cables into the CMA and secure them with the
reclosable cable straps.
4. If you pulled the server out of the rack to make it easier to connect the cables,
push the server into the rack until the slide-rail locks (on the front of the server)
engage the slide-rail assemblies.
You will hear an audible click when the server is in the normal rack position.
Related Information
"Disconnect Cables From the Server" on page 56
■
"Reinstall the Server Into the Rack" on page 190
■
"Return the Server to the Normal Rack Position" on page 191
■
"Power On the Server" on page 194
■
Power On the Server
As soon as the power cords are connected, standby power is applied and the green Power/
OK status indicator on the server front panel blinks. Depending on the configuration of the
firmware, the system might boot. If it does not boot, follow this procedure.
Power on the server by performing one of the following:
Press the Power button on the server front panel.
■
or
Log in to the Oracle ILOM web interface, click Host Management → Power Control and
■
select Power On from the Select Action list.
or
Log in to the Oracle ILOM command-line interface (CLI), and type the following command
■
at the Oracle ILOM prompt:
->
When the server is powered on and the power-on self-test (POST) code checkpoint tests have
completed, the green Power/OK status indicator on the front panel lights and remains lit.
Related Information
"Powering Down the Server" on page 51
■
"Reconnect Data Cables and Power Cords" on page 193
■
194 Oracle Server X6-2 Service Manual • June 2016
start /System