Remove The Server From The Rack - Oracle X6-2 Service Manual

Remove the Server From the Rack

4. While the release latch covers are in the open position, slowly pull the server
forward until the slide-rails latch into a locked position [2].
The server is now in the extended maintenance position. .
Related Information
"Disconnect Cables From the Server" on page 56
■
"Remove the Server From the Rack" on page 58
■
"Reinstall the Server Into the Rack" on page 190
■
Remove the Server From the Rack
Caution -
dismount and carry the chassis.
1. Disconnect all the cables and power cords from the server.
2. Remove the cable management arm (CMA).
For instructions for removing the CMA, see the
Oracle Server X6-2 Installation
3. Extend the server to the maintenance position.
For instructions, see
From the front of the server, pull the green slide-rail release tabs toward the front
4.
of the server, and pull the server out of the rack until it is free of the rack rails.
A slide-rail release tab is located on each slide-rail (see
Note -
the end, and apply pressure as you pull the tab toward the front of the server.
Set the server on a sturdy work surface.
5.
Related Information
"Disconnect Cables From the Server" on page 56
■
"Take Antistatic Measures" on page 59
■
"Extend the Server to the Maintenance Position" on page 56
■
"Reinstall the Server Into the Rack" on page 190
■
58 Oracle Server X6-2 Service Manual • June 2016
The server weighs approximately 18.1 kg (40.0 lbs). Two people are required to
"Extend the Server to the Maintenance Position" on page
To pull the green slide-rail release tab, place your finger in the center of the tab, not on
"Remove the Cable Management Arm" in
Guide.
Figure 4
56.
[frame 2]).