Oracle Server X6-2 Service Manual • June - Oracle X6-2 Service Manual

Remove a Power Supply
Alternatively, to list all known faults in the server, log into the Oracle Solaris OS and issue
the fmadm faulty command, or log into the Oracle ILOM service processor from the Oracle
ILOM Fault Management Shell and issue the fmadm faulty command. For more information
about how to use the Oracle ILOM Fault Management Shell and supported commands, see the
Oracle ILOM User's Guide for System Monitoring and Diagnostics Firmware Release 3.2.x in
the Oracle Integrated Lights Out Manager (ILOM) 3.2 Documentation Library at
oracle.com/goto/ilom/docs.
Note -
You can remove a power supply while the fans are still spinning.
Gain access to the rear of the server where the faulty power supply is located.
2.
If the cable management arm (CMA) is installed, disconnect both CMA left-side
3.
connectors and move the CMA out of the way.
For instructions for disconnecting the CMA left-side connectors, refer
Management Arm" in Oracle Server X6-2 Installation
Caution -
CMA so that it does not hang down under its own weight and stress the right-side connectors;
otherwise, the CMA might be damaged. You must continue to support the CMA until you have
reconnected both of the left-side connectors.
4. Disconnect the power cord from the faulty power supply.
5. Grasp the power supply handle and push the power supply latch to the left [1].
FIGURE 15
82 Oracle Server X6-2 Service Manual • June 2016
The fans of a failed power supply might still be spinning when the system is powered on.
When disconnecting the CMA left-side connectors, use your arm to support the
Removing a Power Supply
to"Remove the Cable
Guide.
http://www.