EB200 Manual
3.18.6.3 POWER
This menu is used to display all parameters of the DC power supply which might be connected.
This menu is obtained by pressing the POWER softkey in the SETUP menu.
Configuration parameters
SOURCE:
BATTERY1 / 2:
TIME TO EMPTY:
When the remaining service time has come down to 10 min, the warning "BATTERY EMPTY IN LESS
THAN 10 MINUTES" comes up in a cyclic fashion.
3.18.6.4 REF
Selection of the reference signal
This menu is obtained by pressing the REF softkey in the SETUP menu.
Configuration parameter
REFERENCE:
Selection of reference frequency source
INTERNAL, EXTERNAL
4052.2000.02
Power source:
DC X1
BATTERY PACK
DC X2
Status of battery 1 / 2:
Display of remaining service time in minutes (overall service time of batteries 1
and 2)
The display is only active for supply from the battery pack.
DC power supply or charger
EB200 Battery Pack
Battery belt
NOT EQUIPPED
NOT IN USE
IN USE
CHARGING
3.54
Operation
E-7
Need help?
Do you have a question about the EB200 and is the answer not in the manual?