Ant (Antenna) - R&S EB200 Manual

EB200 Manual

3.18.4.1 ANT (antenna)

This menu is obtained by pressing the ANT softkey in the RX-CONF menu.
Antenna control via AUX port X8 using 2-digit BCD. The AUX port X8 is the connector with the name X8
at the rear panel of the EB200. For the pin assignment please see interface description in the annex.
Displayed parameters
ANTENNA NUMBER:
ANTENNA CODE:
If the parameter ANTENNA CODE is selected one character at a time can be selected with the softkeys
<- or -> and it can be varied with the spinwheel.
AUX OUTPUT:
At the rear panel of the EB200 on the two 8-bit ports can either the frequency information in BCD four-
digit (1 MHz, 10 MHz, 100 MHz and 1 GHz) or the antenna number with two digits on the one port and
the CTRL byte in binary form on the other port be output. (see also AUX on page 55).
Softkeys
The following two softkeys appear only with installed software option EB200FS (Field Strength).
ANT PAS K-factor table for passive antennae (eg HE200 without amplifier)
ANT AKT K-factor table for active antennae (eg HE200 with amplifier)
4052.2000.02
Antenna number from 0 to 99
5-digit antenna code
FREQ or ANT + CTRL (selection by spinwheel).
3.37
Operation
E-7