Status:trace Register - R&S EB200 Manual

EB200 Manual

4.7.3.7 STATus:TRACe register

This register contains information on ambiguous states of the traces MTRACE, ITRACE, IFPAN,
SSTART and SSTOP.
It can be queried with the commands STATus:TRACe:CONDition? or STATus:TRACe[:EVENt]?.
Table 4-9 Bit allocation of STATus:TRACe register
Bit No. Meaning
0 MTRACE not empty
This bit is set if the MTRACE contains at least one measured value.
MTRACE limit exceeded
1
This bit is set if the number of measured values contained in the MTRACE exceeds the threshold given by the
command TRACe:LIMit[:UPPer] MTRACE.
2 MTRACE total full
This bit is set if the MTRACE is loaded with the maximum number of measured values.
3 ITRACE not empty
This bit is set if the ITRACE contains at least one information value.
4 ITRACE limit exceeded
This bit is set if the number of measured values contained in the ITRACE exceeds the threshold given by the
command TRACe:LIMit[:UPPer] ITRACE.
5 ITRACE total full
This bit is set if the ITRACE is loaded with the maximum number of information values.
6 SSTART changed
This bit is set if one or several start frequencies of the current suppress table have changed.
7 SSTOP changed
This bit is set if one or several stop frequencies of the current suppress table have changed.
8 IFPAN not empty
This bit is set if at least one measured value is stored under IFPAN.
9 IFPAN Limit exceeded
This bit is set if the number of measured values
TRACe:LIMit[:UPPer] IFPAN.
10 IFPAN total full
This bit is set if the maximal number of measured values is stored under IFPAN.
4052.2000.02
stored under IFPAN exceeds the threshold set by
4.137
Remote control
E-7