Pop-Up Editor - R&S EB200 Manual

EB200 Manual Operation

3.16 POP-UP editor

When one of the decimal keys (0 to 9 and the decimal point) is pressed for the first time, a temporary
EDIT window is displayed above the softkey bar; all numerical entries are shown in this window.
The EDIT window does not have preferred values. An exception is the MHZ and the KHZ key. These
two keys will only be displayed if the spinwheel function is connected to a frequency.
If a time parameter was selected, the time units SEC and MSEC are presented as ENTER keys.
While the editor window is open, you can continue to use the spinwheel to adjust the selected
parameter (e.g. FRQ or F-START).
Value transfer with the ENT key
When the Enter key is pressed, the value becomes the value of the parameter displayed in the
spinwheel selector window. Either FRQ or MEM is displayed in the spinwheel selector window or the
name of a selected parameter from the configuration menu.
Value transfer with the FRQ, MEM, SQU, MGC, TONE, SAVE and RCL keys
The value can also be turned into the value of the parameter in question with one of these function-
linked Enter keys.
4052.2000.02 3.21 E-7