Table of Contents
Advertisement
EB200 Manual
3.17 Changing configuration parameters
A selected parameter can be changed in the F-SCAN, M-SCAN and D-SCAN configuration menus and
in the SETUP submenus. Parameters can be selected by the SEL softkey.
Numerical and non-numerical parameters can be changed by the spinwheel and the decimal keypad.
In the case of non-numerical parameters, the digits referred to below are interpreted in the following
way:
'0'
corresponds to OFF
'1'
corresponds to ON
'.'
corresponds to the infinity sign (for example with the parameter CYCLES)
As the EB200 does not have any CURSOR keys, toggle and increment or decrement functions are
implemented by means of the spinwheel.
In order to be able to also enter non-numerical parameters when the spinwheel is locked, the numbers
0, 1, 2, etc. refer to these parameters correspondingly. Thus by pressing a number and the ENT button
a parameter is selected.
4052.2000.02
3.23
Operation
E-7
Advertisement
Table of Contents
Troubleshooting
