D-Scan (Option) - R&S EB200 Manual

EB200 Manual

3.18.3 D-SCAN (option)

This menu is obtained by pressing the D-SCAN softkey in the MAIN menu.
The marker position is highlighted through a dashed line. To the right next to the marker, the level
measured at the marker position is represented in a tracking window. Thus individual signals can be
measured for level and frequency.
Softkeys
The softkeys display the current corresponding status.
NORM DIFF toggle key:
RUN STOP toggle key:
BW ZOOM toggle key:
A
^ TO start action:
The frequency marker jumps over to the next relative level maximum that is to the right of the marker in
the DSCan spectrum at SQU OFF. If the squelch function is switched on, the frequency marker is set to
the next level maximum on the right above the squelch line. If no further level maximum is available on
the right of the current level maximum, the frequency marker jumps over to the first level maximum on
the left in the DSCan spectrum.
RNG 60 4-way toggle key:
CONFIG Switch over to the configuration menu D-SCAN CONFIG
Symbols
^ Marker or receiver frequency
|<- Start frequency
->| Stop frequency
<--> Span frequency range ( = stop frequency - start frequency)
->|< Center frequency ( = stop frequency + start frequency / 2)
Note:
Due to system conditions the sweep width of 9 to 200 kHz for IF filter bandwidth 15 to 150 kHz cannot
be used. The sweep width of 9 to 60 kHz for IF filter bandwidth <15 kHz cannot be used..
4052.2000.02
differential or normal spectrum
sweep mode: listening mode (frozen spectrum)
change-over to bandwidth-zoom mode
marker to peak
Y-scaling (20, 40, 60, 80 dB span)
3.32
Operation
E-7