System Menu - R&S EB200 Manual

EB200 Manual

3.18.4.4 SYSTEM menu

This menu is obtained by pressing the SYSTEM softkey in the RX-CONF menu.
Display of software version and series number
MAIN CPU
IF DSP
IF PAN DSP
FP CTRL
DC-CONVERTER CPU
SERIAL NUMBER
Note:
From MAIN CPU version 2.31 onwards, the configuration of the IF section can be determined from the
version of the DSP software (IF DSP).
If the version is shown to be less than V03.00, the IF section is equipped with DDC1.
If the version is shown to be greater than V03.00, the IF section is equipped with DDC2.
Configuration with DDC2 is the precondition for future software options such as EB200CM and the
configuration of a measuring time. For IF sections with DDC2 no offset measurement is possible in the
CW, USB, LSB and IQ modes.
Softkeys
RESET Reset to the Rohde & Schwarz default settings. The same function is triggered via
remote control by the command *RST.
PROTECT Branches to the password entry menu
SW OPT Branches to the menu for SW options
4052.2000.02
Main controller
DSP for the IF-section
DSP for IF-panorama (option)
Keyboard controller
Controller for DC/DC converter
Receiver serial number
3.40
Operation
E-7