Aux - R&S EB200 Manual

EB200 Manual

3.18.6.5 AUX

Configuration of the AUX-port parameters
This menu is obtained by pressing the AUX softkey in the SETUP menu.
Configuration parameters
CTRL: Setting the AUX bits of socket X8 (rear panel)
0 to 255
OUTPUT: FREQ or ANT+CTRL
The two rear-panel 8-bit ports can be used to output the frequency information in four-digit
BCD (1 MHz, 10 MHz, 100 MHz and 1 GHz) or the two-digit antenna number at one port and
the binary CTRL byte at the other.
The connector X8 is located at the rear panel of EB200. For its pin assignment refer to the interface
description contained in the manual.
4052.2000.02 3.55
Operation
E-7