F-Scan - Config - R&S EB200 Manual

EB200 Manual

3.18.2.1 F-SCAN - CONFIG

This menu is obtained by pressing the CONFIG softkey in the F-SCAN menu.
,
Softkeys
RUN- Scan starts from the current frequency or the stop frequency with decreasing
frequency. There is a menu change after F-SCAN
RUN+ Scan starts from the current frequency or the start frequency with increasing frequency.
There is a menu change after F-SCAN
SUPP Goes to the F-SCAN CONFIG SUPP configuration menu
Configuration of the scan range parameters
Select F-scan range
|<- Start frequency: 10 kHz to 3 GHz
->| Stop frequency: 10 kHz to 3 GHz
<-> Step frequency: 1 Hz to 10 MHz
Configuration of the scan-run parameters
T_DWELL Dwell time:
T_NOSIG Continues under signal control after pause:
CYCLES Number of scan cycles:
Note:
The scan may automatically go from the RUN state to the STOP state when the CYCLE-COUNT is
reached.
4052.2000.02
0.0 to 10.0 sec /infinity
OFF/ 0.0 to 10.0 sec
1 to 1000 / infinity
3.30
Operation
E-7