Softkeys In The Editor Window - R&S EB200 Manual

EB200 Manual Operation

3.16.1 Softkeys in the editor window

MHZ softkey
The basic unit of all frequencies is always MHz. From that this softkey has the same importance as the
ENT key does.
KHZ softkey
The principal units in all menus are always MHz. To make kHz entries easier, a KHZ softkey has also
-3
been provided. Pressing the KHZ key multiplies the entered value by a factor of 10 and transfers it
(Enter function). If the selected parameter is not a frequency, the KHZ softkey is disabled and not
displayed.
SEC softkey
The basic unit of all times is always seconds. From that this softkey has the same importance as the
ENT key does.
MSEC softkey
The basic unit of all times is always seconds. In order to facilitate the input of milliseconds, there is the
-3
MSEC softkey in addition. This causes that the entered value is multiplied by the factor 10 and taken
over (enter function). If the selected parameter is not a time, no MSEC softkey appears then.
<-
softkey
The arrow key is used to clear falsely entered characters.
ESC softkey
The ESC softkey as well as the ESC key closes the editor window without any value being transferred.
Sign change
By pressing the +/- softkey, you change the sign of a number.
4052.2000.02 3.22 E-7