Display - R&S EB200 Manual

EB200 Manual
Configuration parameters
TEST POINT OFF or selection of a test point of the subassemblies. When a test point is selected, a
permanent display windows opens.
The window contains the name of the subassembly, the selected test point, the current voltage in mV
and, if necessary, an arrow that indicates whether is above or below the limit.
Display parameters
MIN: The permissible minimum test point voltage (in mV)
MAX: The permissible maximum test point voltage (in mV)
If no min. and max. values are displayed, this test point is not relevant for the current state of the unit.
The test-point window without minimum and maximum values can be displayed in every menu of the
unit. This means that it is possible to observe a particular point in all the unit's operating states.
Menus in which the SEL key has no function and in which this key is pressed, a test point can be
selected by spinwheel.
4052.2000.02 3.44
Operation
E-7