Table of Contents
Advertisement
Chapter 3
Mounting the Kinetix 6000M System
32
Mount the IPIM Module
All modules mount to the power rail using the same technique.
1. Determine the next available slot and module for mounting. Refer to
Determine Mounting Order
2. Remove the protective covers from the power rail connectors.
3. Inspect the module connector pins and power rail connectors and remove
any foreign objects.
ATTENTION: To avoid damage to the pins located on the back of each
module and to make sure that module pins mate properly with the
power rail, hang modules as explained below.
The power rail must be mounted vertically on the panel before hanging
modules on the power rail.
4. Hang the module mounting bracket from the slot on the power rail.
Mounting Bracket
Power Rail Slot
5. Pivot module downward and align the guide pin on the power rail with the
guide pin hole in the back of the module.
Guide Pin
Guide Pin Hole
Rear View
6. Gently push the module against the power rail connectors and into the
final mounting position.
Rockwell Automation Publication 2094-UM003A-EN-P - May 2012
on
page
30.
Slots for Additional Modules
Power Rail
Power Rail
Side View
Pivot module
downward and align
with pin
Advertisement
Table of Contents
