Allen-Bradley Kinetix 6000M User Manual page 126

Appendix C Upgrading the Kinetix 6000M System Firmware
Verify the Firmware Upgrade
126
Follow these steps to verify your firmware upgrade was successful. This procedure
uses an IDM unit as an example, but applies to IPIM modules too.
TIP Verifying the firmware upgrade is optional.
1. Open your RSLinx software.
2. From the Communications pull-down menu, choose RSWho.
3. Expand your Ethernet node, Logix backplane, and EtherNet/IP network
module.
4. Right-click the device (IPIM or IDM) and choose Device Properties.
The Device Properties dialog box opens.
5. Verify the new firmware revision level.
6. Click Close.
Rockwell Automation Publication 2094-UM003A-EN-P - May 2012