Table of Contents
Advertisement
4
Expanding Your Measurement Experience
e5505a_conn_diag_dialog
rev 1 23 jun 04
Figure 56 Connect diagram dialog box
4
The test set's signal input is subject to the limits and characteristics in
C A UTI ON
page 89.
To prevent damage to the test set's hardware components, do not apply the input
signal to the test set's signal input connector until the input attenuator (Option 001)
has been set by the phase noise software, which occurs when the connection
diagram appears.
5
6
88
Connect your DUT and reference sources to the test set at this time.
Confirm your connections as shown in the Connect Diagram
•
The input attenuator (Option 001 only) has now been correctly
configured based on your measurement definition.
Press Continue.
•
As the system performs the calibration routines, various status messages
appear on the display. When the last message—Measuring PLL
suppression—appears, you can choose to continue the routine or stop it.
Press Continue using Adjusted Loop Suppression to continue making the
noise measurement, or press Abort to stop the measurement. (For
descriptions of the messages, see
time to read through the descriptions while the system completes the
routines.)
"Status messages"
on page 74. You have
Agilent E5505A User's Guide
(Figure
56).
Table 9
on
Advertisement
Table of Contents
