Table of Contents
Advertisement
3
Note that the source parameters entered for step 2 in
NO T E
appropriate for the reference source you are using. To change these values, refer to
on page 68, then continue with
measurement"
4
Figure 37 Enter Source Information
Agilent E5505A User's Guide
Click the Open button.
The appropriate measurement definition parameters for this example have
been pre-stored in this file.
has been entered for this measurement example.)
on page 71.
Using
Figure 37
as a guide, navigate to the Sources tab.
Enter the carrier (center) frequency of your DUT (5 MHz to 1.6 GHz).
a
Enter the same frequency for the detector input frequency.
b
Enter the VCO (Nominal) Tuning Constant (see
c
Enter the Tune Range of VCO (see
d
Enter the Center Voltage of VCO (see
e
Enter the Input Resistance of VCO (see
e5505a_user_enter_source_info
24 Jun 04 rev 3
Expanding Your Measurement Experience
Table 7
on page 79 lists the parameter data that
Table 7
step 4
below. Otherwise, go to
Table
5).
Table
Table
on page 79 may not be
"Beginning the
Table 5
on page 68).
5).
5).
4
Table 5
67
Advertisement
Table of Contents
