Figure 110. Enter Source Information - Agilent Technologies e1420b User Manual

4
Note that the source parameters entered for step 2 in
NO T E
appropriate for the reference source you are using. To change these values, refer to
on page 162, then continue with
measurement"
5
Figure 110 Enter source information
Agilent E5505A User's Guide
Click the Open button.
The appropriate measurement definition parameters for this example have
been pre-stored in this file.
that has been entered for the RF Synthesizer using DCFM measurement
example.
on page 165
Using Figure 92 as a guide, navigate to the Sources tab.
a Enter the carrier (center) frequency of your DUT (5 MHz to 1.6 GHz).
Enter the same frequency for the detector input frequency.
Enter the VCO (Nominal) Tuning Constant (see
b
Enter the Tune Range of VCO (see
c
Enter the Center Voltage of VCO (see
d
Enter the Input Resistance of VCO (see
e
e5505a_user_enter_source_info
24 Jun 04 rev 3
Absolute Measurement Examples
Table 25 on page 185 lists the parameter data
Table 22
step 5 below. Otherwise, go to
Table 20).
Table
Table
on page 171 may not be
"Beginning the
Table 20 on page 162).
20).
20).
6
Table 20
161