Table of Contents
Advertisement
13 View the test set information in the Asset
E5500_asset_mgr_screen
23 Mar 04 rev 1
14 To change information about an asset,
You have just used the Asset Manager to configure the N5500A test set. The
process for configuring any asset is essentially the same. Repeat this
procedure for all of the assets that you wish to add to your N5505A system.
You must add the test set and the PC digitizer to perform the confidence test
(see
configuration procedure follows on
Table 74
in the system.
Agilent E5505A User's Guide
Manager window and confirm that it is correct.
double-click on the asset in the left pane and
change the information in the box that appears.
"Performing a Confidence Test"
on page 435 contains the default GPIB addresses for the instruments
PC Components Installation
•
The left pane shows the list of asset roles
and assets. The right pane shows the
asset information. The right pane is
information only. The left pane is active.
on page 39). The PC digitizer
page
432.
19
431
Advertisement
Table of Contents
