Table of Contents
Advertisement
4
Note that the source parameters entered for step 2 in
NO T E
appropriate for the reference source you are using. To change these values, refer to
Table
step 5
5
.
Figure 86 Enter source information
Agilent E5505A User's Guide
Click the Open button.
The appropriate measurement definition parameters for this example have
been pre-stored in this file.
that has been entered for the Stable RF Source measurement example.
14, "Tuning characteristics for various sources," on page 132, then continue with
below. Otherwise, go to
Using
Figure 86
on page 131 as a guide, navigate to the Sources tab.
Enter the carrier (center) frequency of your DUT (5 MHz to 1.6 GHz).
a
Enter the same frequency for the detector input frequency.
b
Enter the VCO (nominal) Tuning Constant. (For values, see
page 132).
Enter the Tune Range of VCO (see
c
Enter the Center Voltage of VCO (see
d
Enter the Input Resistance of VCO (see
e
Absolute Measurement Examples
Table 16
on page 143 lists the parameter data
Table 16
"Beginning the measurement"
Table
14).
Table
Table
on page 143 may not be
on page 136:
Table 14
14).
14).
6
on
131
Advertisement
Table of Contents
