Figure 129. Connect Diagram For The Rf Synthesizer (Efc) Measurement - Agilent Technologies e1420b User Manual

Phase noise measurement system
Hide thumbs Also See for e1420b:
Table of Contents

Advertisement

6
Absolute Measurement Examples
3
e5505_user_connect_diag_8663a
24 Jun 04 rev 3
Figure 129 Connect diagram for the RF synthesizer (EFC) measurement
4
• The input attenuator (Option 001 only) is now correctly configured based
A
The test set's signal input is subject to the limits and characteristics in
C A UTI ON
page 181.
To prevent damage to the test set's hardware components, do not apply the input
signal to the test set's signal input connector until the input attenuator (Option 001)
has been set by the phase noise software, which will occur when the connection
diagram appears.
180
When the Connect Diagram dialog box appears, click on the hardware
drop-down arrow and select your hardware configuration from the list. See
Figure
129.
N5500A
Connect your DUT and reference sources to the test set at this time.
Confirm your connections as shown in the connect diagram.
on your measurement definition.
on
Table 24
Agilent E5505A User's Guide

Advertisement

Table of Contents
loading

Table of Contents