Table of Contents
Advertisement
4
Expanding Your Measurement Experience
3
The source parameters shown in
NO T E
reference source you are using. To change these values, refer
characteristics for various sources," on page 83, then continue with
Otherwise, go to
4
Figure 49 Sources tab in define measurement window
82
Click the Open button.
•
The appropriate measurement definition parameters for this example
have been pre-stored in this file.
data that has been entered for the RF Synthesizer using a DCFM
measurement example.
"Beginning the measurement"
Using
Figure 49
on page 82 as a guide, navigate to the Sources tab
a
Enter the carrier (center) frequency of your DUT (5 MHz to 1.6 GHz);
enter the same frequency for the detector input frequency.
b
Enter the VCO (Nominal) Tuning Constant (see
c
Enter the Tune Range of VCO (see
d
Enter the Center Voltage of VCO (see
e
Enter the Input Resistance of VCO (see
e5505a_user_enter_source_info
24 Jun 04 rev 3
Table 10
on page 94 lists the parameter
Table 10
on page 94 may not be appropriate for the
on page 87.
Table 8
on page 83).
Table 8
Table 8
toTable
8, "Tuning
step 4
below.
Table 8
on page 83).
on page 83).
on page 83)
Agilent E5505A User's Guide
Advertisement
Table of Contents
