Table of Contents
Advertisement
19
PC Components Installation
Overview
Your E5505A Phase Noise Measurement System system arrives with all
necessary phase noise components installed in the system PC. However, if you
need to re-install the phase noise hardware and/or software in your E5505A
system PC for any reason, use the procedures in this chapter. The chapter
leads you through the process step-by-step. To prevent errors in the
installation process, it is important to complete the tasks in the order
presented, and to complete each one before proceeding to the next.
Installing the required phase noise software and hardware in the system PC
involves the following tasks, in the order listed:
1
2
3
4
5
6
7
8
If you're re-installing any of the phase noise hardware and software components in the list,
NO T E
be sure to uninstall all components, then reinstall them in the order shown above.
If you encounter any problems with the installation, contact your Agilent Technologies
NO T E
Service Center. Contact information is in
Information."
406
Install software for the PC digitizer card.
Install the PC digitizer card (PCB).
Install the GPIB interface card (PCB).
Connect cables between the system PC and the phase noise test set.
Install the Agilent I/O libraries.
Complete the I/O devices configuration.
Install the E5500 Phase Noise Measurement software.
Configure the system instruments.
Appendix
A, "Service, Support, and Safety
Agilent E5505A User's Guide
Advertisement
Table of Contents
