Table of Contents
Advertisement
12
AM Noise Measurement Examples
e5505a_user_connect_diag_AM_noise
27 Jun 04 rev 3
Figure 246 Connect diagram for the AM noise measurement
4
• The input attenuator (Option 001 only) is now correctly configured based
The test set's signal input is subject to the limits and characteristics in
C A UTI ON
page 309.
To prevent damage to the test set's hardware components, do not apply the input
signal to the test set's signal input connector until the input attenuator (Option 001)
has been set by the phase noise software, which will occur when the connection
diagram appears.
308
Connect your DUT and reference sources to the test set at this time.
Confirm your connections as shown in the connect diagram.
on your measurement definition.
Table 47
on
Agilent E5505A User's Guide
Advertisement
Table of Contents
