PC Digitizer Software: Phase 1
Install Windows
NO T E
software and drivers, before beginning the procedures in this section. See the PC and
software manufacturers' documentation for their installation requirements and procedures.
This procedure applies specifically to the PC digitizer card supplied with the
N5505A system. For this and any other PC digitizer card, always follow the
manufacturer's instructions.
To install the PC digitizer software
Step
1 Make sure your PC and display are on.
2 Place the manufacturer's installation CD-ROM in
3 Follow the instructions in the installation wizard.
4 Shutdown and power off the PC and its
Agilent E5505A User's Guide
®
XP Professional
the CD-ROM drive of the PC.
peripherals. Proceed to the phase noise
hardware installation procedures.
®
operating system, and all necessary PC-specific
Action
•
The installation wizard dialog box should
automatically appear after a few
seconds. If it doesn't, start it this way:
•
From the Start menu, select My
Computer and the CD-ROM drive.
•
Find and select the file setup.exe. Click
OK.
•
Accept the defaults.
•
Leave the CD-ROM in the drive. Once you
have installed the necessary hardware
and powered on the PC again, the
installation wizard will lead you through
completing the PC digitizer software
installation process.
PC Components Installation
19
407