RF electronic calibration (ECal) modules and PC software
This product family provides electronic calibration (ECal) capability. With ECal, the usual
calibration kit standards are replaced by one solid-state calibration module. A full two-port
calibration can be done with a single connection, with reduced errors and wear on
connectors. ECal requires the 85097A/B PC interface kit, an 85090-series calibration
module with the appropriate connector type, and a network analyzer with firmware
version 7.68 and above.
NOTE
For network analyzers with firmware versions between 7.60 and 7.68, a PC
with Windows®
85097A/B PC interface kit is used to perform the ECal calibration.
• 85097A/B ECal PC interface kit and software
— Contains PC interface module for connecting an ECal module to a PC or a network
analyzer (with firmware version 7.68 and above) and PC ECal control software.
• 85091B RF ECal module (30 kHz to 9 GHz), 7-mm connectors
• 85092B RF ECal module (30 kHz to 9 GHz), 50 Ω type-N (m) to 50 Ω type-N (f)
connectors
— Option 00F substitutes type-N (f) to type-N (f) RF ECal module.
— Option 00M substitutes type-N (m) to type-N (m) RF ECal module.
— Option 00A adds:
— type-N (f) to type-N (f) adapter
— type-N (m) to type-N (m) adapter
• 85093B RF ECal module (30 kHz to 9 GHz), 3.5-mm (m) to 3.5-mm (f) connectors
— Option 00F substitutes 3.5-mm (f) to 3.5-mm (f) RF ECal module.
— Option 00M substitutes 3.5-mm (m) to 3.5-mm (m) RF ECal module.
— Option 00A adds:
— 3.5-mm (f) to 3.5-mm (f) adapter
— 3.5-mm (m) to 3.5-mm (m) adapter
• 85098B RF ECal module (30 kHz to 7.5 GHz), 7-16 (m) to 7-16 (f) connectors
— Option 00F substitutes 7-16 (f) to 7-16 (f) RF ECal module.
— Option 00M substitutes 7-16 (m) to 7-16 (m) RF ECal module.
— Option 00A adds:
— 7-16 (f) to 7-16 (f) adapter
— 7-16 (m) to 7-16 (m) adapter
1. Windows is a U.S. registered trademark of Microsoft Corporation.
1
95, 98, 2000 or NT 4.0 loaded with software from the
Options and Accessories
Accessories Available
7-7