Cleaning The Document Hold-Down Unit - GRAPHTEC CS2000 Service Manual

5.2 Cleaning the Document Hold-Down Unit

(1) Turn off the scanner.
(2) Remove the document hold-down unit as described in Section 5.1 "Removing and Mounting the
Document Hold-Down Unit".
(3) Lay the document hold-down unit on a stable surface, with the underside facing the side as shown.
(4) Wipe clean the underside of the document hold-down unit (see below) using a soft cloth that has been
soaked in water or diluted neutral detergent and thoroughly wrung out.
Scanning may be affected if the underside of the document hold-down unit becomes scratched or dirty. It must be
cleaned when necessary.
(5) Wipe the document hold-down unit once again using a soft, dry cloth (remove all moisture).
(6) Reattach the document hold-down unit as described in Section 8.2 "Document Hold-Down Unit."
CS2000-UM-251-9370
Underside
5-3
5. DAILY MAINTENANCE