Front Guide - GRAPHTEC CS2000 Service Manual

8.15 Front Guide

Disassembly procedure
8.2
p.8-2
Detaching the document
hold-down unit
Detaching the front guide
(1) Remove the two black M3L6 binding head screws and four silver M3L6 binding head screws.
(2) Pull out the front guide.
Reattaching the front guide
(1) Make the necessary adjustments to make sure that the guide does not touch the drive roller and that no
gaps are wide enough for a document to slip into them. When you finish, tighten the M3L6 binding head
screws on the left-hand side.
(2) Tighten other screws to reattach the front guide in the reverse order in which it was detached.
CS2000-UM-251-9370
8.4
Detaching the side covers
This Section
Detaching the front guide
M3L6 binding head screws
Inside bottom plate L Inside bottom plate L
M3L6 M3L6
binding head screws binding head scre ws
8. DISASSEMBLING AND ADJUSTING MECHANICAL PARTS
8.6
p.8-5
Detaching the front cover
8.13
Detaching the separator
plate (the front plate only)
M3L6 binding head screws M3L6 binding head scre ws
8-19
8.8
p.8-7
Detaching the large
bottom plate
8.9
p.8-15
Detaching the main board
(not for securing it to the jig)
Front guide
p.8-9
p.8-10