Drive Rollers - GRAPHTEC CS2000 Service Manual

8.22 Drive Rollers

Disassembly procedure
8.2
p.8-2
Detaching the document
hold-down unit
8.14
p.8-16
Detaching the pinch roller
units
8.15
p.8-18
Detaching the front guide
Detaching the drive rollers
(1) Detach the right-hand E-ring.
(2) Push the bearings (two per side) from inside the scanner unit to remove them.
(3) Remove the halves of each drive roller one at a time.
Reattaching the drive rollers
(1) Reattach the drive rollers by reversing the sequence of steps in which they were detached.
(2) Make sure the right-hand and left-hand halves of the roller are attached to the E-ring and pulley,
respectively.
Attach to the pulley.
CS2000-UM-251-9370
8. DISASSEMBLING AND ADJUSTING MECHANICAL PARTS
8.4
p.8-5
Detaching the side covers
8.13
p.8-15
Detaching the separator
plates
8.16
p.8-19
Detaching the rear guide
Drive rollers Dr iv e rollers
Bearings Bear ings
E-rings E-r ings
8-28
8.5
p.8-6
Detaching the top cover
8.9
p.8-10
Detaching the main board
(not for securing to the jig)
8.21
p.8-26
Detaching the pulleys
Attach to the E-ring.
8.6
p.8-7
Detaching the front cover
8.8
p.8-9
Detaching bottom plate
large
This Section
Detaching the drive rollers