GRAPHTEC CS2000 Service Manual page 42

(5) Change the "Maximum Sync Transfer Rate" for the corresponding SCSI ID.
If (for example) your scanner's SCSI ID is 2, select "Sync Transfer Rate (MB/Sec)" for the SCSI Device
ID #2 and press the "Enter" key. Then use the down-arrow key to select "10.0" and press the "Enter" key.
(6) Press the "Esc" key twice. When "Save Changes Made?" appears, select "Yes" and press the "Enter"
key.
(7) Press the "Esc" key. When "Exit Utility?" appears, select "Yes" and press the "Enter" key.
(8) When "Please press any key to reboot" appears, remove the floppy disk and press any key. At this time,
your PC will restart.
Checkpoint: If you have a FastSCSI card such as AHA-2910C or AHA-1520B, you do not need to change the trans-
fer rate.
CS2000-UM-251-9370 4-22
4. OPERATION AND CONNECTION