Cleaning The Document Hold-Down Unit - GRAPHTEC CS2000 User Manual

5.2 Cleaning the Document Hold-Down Unit

(1) Turn off the scanner.
(2) Remove the document hold-down unit as described in Section 5.1, "Removing and
Mounting the Document Hold-Down Unit".
(3) Lay the document hold-down unit on a stable surface, with the underside facing the
side as shown.
(4) Wipe clean the underside of the document hold-down unit (see below) using a soft
cloth that has been soaked in water or diluted neutral detergent and thoroughly wrung
out.
Scanning may be affected if the underside of the document hold-down unit becomes
scratched or dirty. It must be cleaned when necessary.
(5) Wipe the document hold-down unit once again using a soft, dry cloth (remove all
moisture).
(6) Mount the document hold-down unit as described in Section 5.1, "Removing and
Mounting the Document Hold-Down Unit".
CS2000
Underside
5. DAILY MAINTENANCE
5 – 3