Left Access Cover; Lamp Door - Christie CP4230 Service Manual

5.4.7 Left Access Cover

Remove the left access cover, which is located next to
the lamp door to access any of the components in the
IOS and liquid cooling compartments.
(Estimated Replacement Time: 4 minutes)
1. Using a #2 Phillips
screws at the top of the cover. (Figure 5-7)
2. Pull the cover up to clear the bottom tabs and
remove.
3. When re-installing the cover, align and insert the
bottom tabs first, then secure the cover with the
screws.

5.4.8 Lamp Door

Remove the lamp door to access components in the lamp compartment. The lamp door can be removed
entirely from the projector or it can remain tethered and opened up to 90°. Fixed to the inside of the door is a
set of commonly used hex keys required during lamp replacement.
(Estimated Replacement Time: 4 minutes)
1. Unlock and open the lamp door.
(Figure 5-8)
2. Unhook the securing tether on the
right-side of the door.
3. To release the door, slide the locking
pin (accessible through the cutout
located on the right side of the door)
towards the inside of the door.
CP4230 Service Manual
020-100622-04 Rev. 1 (05-2016)
, loosen the three captive
™
Section 5: Parts and Module Replacement
Figure 5-7 Remove Left Access Cover
Figure 5-8 Open Lamp Door
5-9