Remove The Lamp Door Interlock; Replace The Lamp Power Supply - Christie CP2215 Service Manual

4. Remove the rear skin to remove the rear feet or remove the front skin to remove the front feet.
See Remove the Rear Skin on page 26
5. Hold the top nut with a ratchet and then turn the locking nut on the foot to remove it.
6. Remove the foot.

Remove the Lamp Door Interlock

The lamp door interlock is located at the rear of the projector. The interlock is activated when the low
security key is used to open the lamp door.
1. Turn the lamp off and cool the projector for at least 15 minutes.
2. Turn the projector off and then disconnect it from AC power.
3. Unlock and then open the lamp door.
4. Remove the 2 nuts from the interlock.
5. Disconnect the two interlock wires.

Replace the Lamp Power Supply

The LPS comes with the lamp igniter built in. The LPS is located at the rear of the projector, attached
to the base plate.
1. Turn the lamp off and cool the projector for at least 15 minutes.
2. Turn the projector off and then disconnect it from AC power.
3. Remove the lamp. See
4. Remove the rear skin. See
5. Remove the cathode and anode lamp blower assembly. See
Blowers (Fans 1 and 2)
6. Remove the reflector assembly. See
7. Remove the lamp adjust assembly. See
8. Remove the 3 screws securing the LPS to the projector base.
9. Remove the screw securing the LPS to the center structure.
10. Remove the P-clips securing the AC harness to the LPS.
11. Disconnect the AC power and communication harnesses.
12. Tilt the LPS up and slide it out of the projector.
CP2215 Service Manual
020-101226-03 Rev. 1 (10-2015)
or Remove the Front Skin on page
Remove the Existing Lamp
Remove the Rear Skin
on page 46.
Remove the Reflector Assembly
Remove the Lamp Adjust Assembly
Parts and Module Replacement
on page 28.
on page 26.
Remove the Cathode and Anode
on page 34.
22.
on page 34.
33