Install The Lens; Remove And Replace The Lamp Door Interlock Switch - Christie J series 2.0kW Service Manual

4.5.41 Install the Lens

1. Remove the rear lens cap from the lens.
2. Rotate the lens locking clamp to the OPEN position.
3. Install the lens straight into the lens mount opening all the way back, without turning. Make sure the lens
connector lines up with the connector on the projector.
4. Hold the lens flat against the lens mount and then rotate the lens clamp clockwise to lock the lens in
position.
5. Tighten the red security screws provided with the lens mount, or hand tighten the lens retaining screws
attached to the lens.
WARNING
6. Remove the front lens cap.

4.5.42 Remove and Replace the Lamp Door Interlock Switch

1. Power down the projector:
a. Turn the projector off and allow the projector to cool for a minimum of 5 minutes.
b. Disconnect the AC power cord from the rear of the projector.
1. Loosen the 2 quick release screws on the lamp door.
2. Disconnect the 2 lamp interlock switch connectors.
3. Remove the 2 screws securing switch and bracket holder.
J Series 2.0, 2.4, and 3.0kW Service Manual
020-100739-01 Rev. 1 (01-2012)
You must install the lens red security screws or the lens retaining screws if the projector
is installed in an elevated position.
Section 4: Parts and Module Replacement
4-45