Installing And Setting Up The System; Installing Hardware; Installing Pc Software; Configuring The Ip Address Of The Pc - ETC GDS CueSystem User Manual

Installing and Setting Up the System

Installing Hardware

See the CueSystem Control Desks & Playback Units Installation Guide and the CueSystem
CueSpider Outstation Installation Guide for installation instructions. CueSystem documents
are available for free download at www.etcconnect.com/cuesystem.

Installing PC Software

Download the PC software from
Follow the on-screen prompts to install the software.

Configuring the IP Address of the PC

After you install the software, you must change the IP address, subnet mask, and gateway of
the PC to match the CueSystem network IP address scheme. For a single client PC, we
recommend that you use the following settings:

Starting the Software and Connecting to the Network

One CueSystem desk or playback unit must be assigned as a master controller, storing all
show file and setup information for the rest of the system. By default, this unit is a playback
unit. If no playback unit is present, the master controller must be a desk. For more
information, see
22.
After you start the software, you must enter the IP address of the master controller for initial
setup.
Step 1:
Installing and Setting Up the System
www.etcconnect.com/cuesystem
Protocol
IP Address
Subnet Mask
Gateway
Adopting Devices to the Local Network
Double-click the CueSystem icon on your desktop. The CueSystem software application
opens.
and run the installer.
Address
10.101.167.125
255.255.0.0
10.101.1.1
page 8
on and
Controller page
on
5