Restore Default Settings; Update Firmware - ETC Desire Fresnel User Manual

Export Fixture Event Log
The fixture routinely saves the last 50 changes to the fixture settings in an event log. The log
identifies the way in which the settings were changed (for example, whether the settings were
changed using the UI or via RDM). You can export the event log to a USB flash drive to aid in
troubleshooting any issues with the fixture.
1. Insert the USB flash drive in the USB port on the rear of the fixture (see
page 6 ).
2. Press the Menu button (
menu: Local Settings > USB > Save Events.
3. The display shows the file name to be saved (for example, delog00.xml). Press the green
encoder (for the Save icon
When the display returns to the USB screen, the process is complete, and the data is saved
to a file on the USB flash drive.
4. Remove the USB flash drive from the USB port.

Restore Default Settings

1. Press the Menu button (
menu: Local Settings > Restore Defaults.
2. When the screen prompts you to confirm, press the green encoder (for the OK icon
continue. The screen shows a confirmation message after default settings have been
restored. After the default settings have been restored, the DMX mode will be 3 Ch RGB.

Update Firmware

When fixtures are connected to data, you can update firmware directly using UpdaterAtor. For
information on UpdaterAtor, see the UpdaterAtor Software QuickGuide and the UpdaterAtor
Software Release Note , which you can download from etcconnect.com.
You can also update firmware using a USB flash drive. After you update a single fixture using a
USB flash drive, you can update all fixtures that are connected via wired DMX from that fixture.
Update a Single Fixture Using a USB Flash Drive
1. Visit etcconnect.com
and then save the firmware file to a USB flash drive. For information on UpdaterAtor, see
the UpdaterAtor Software QuickGuide and the UpdaterAtor Software Release Note ,
which you can download from etcconnect.com.
2. Insert the USB flash drive in the USB port on the rear of the fixture (see
page 6
).
3. Press the Menu button (
menu: Local Settings > USB > Update Firmware.
4. Use the Intensity encoder to navigate to the firmware update file, and then press the
Intensity encoder to begin the firmware update. The firmware update includes several
steps:
a. Copying the files to the fixture: A progress meter displays as the files are copied to
the fixture.
b. Verifying the files: The ETC logo displays on the top half of the screen as the fixture
verifies the files. You can safely remove the USB drive at this time.
c. Updating the fixture: The fixture installs the updated firmware files.
Troubleshooting and Maintenance
), and then use the Intensity encoder to navigate through the
) to save the file to the USB flash drive.
), and then use the Intensity encoder to navigate through the
or use UpdaterAtor to get the updated firmware file for the fixture,
), and then use the Intensity encoder to navigate through the
User Interface on
) to
User Interface on
23